why is ac unit not cooling

make our lives easier, which they usually do. Until, that is, they start leaking, heating imperfectly, burning toast they were supposed to brown, and generally malfunctioning. Although they may seem complicated, most home appliances work on fairly basic principles. And while there is a common sentiment these days that it's less expensive to simply buy a new appliance than to have it repaired, many of the minor problems that plague these devices can be dealt with using a minimum of time and effort. So the next time an appliance is on the fritz, consider the local landfill, and then decide whether to fix it or ditch it.There's water pooling around your central air-conditioning unit (or perhaps dripping from the ceiling directly below the unit location).According to Glenn C. Hourahan, vice president of research and technology for Air Conditioning Contractors of America, it's likely that the drain pan for the air-conditioning evaporator coil is overflowing due to a blockage in the drain line.

"Depending on the type of unit you have, the evaporator may drain to the outside of the house or to a floor drain in the basement. Either way, use a long wire (an unwound coat hanger will work) to clear any blockages that may occur near the mouth of the drainpipe. If that doesn't correct the problem, cautiously (you don't want to introduce much additional water into an already flooded pan) use a hose to force a short blast of water up into the drainpipe and through the drain trap and drain pan. This may free accumulated dirt and allow the evaporator to drain freely for some time." If that doesn't do the trick, Hourahan recommends turning off the air conditioner to avoid further water overspill and calling a licensed HVAC contractor to have a NATE-certified service technician address the situation.Signs of Central Air-conditioning CrisisCentral air-conditioning systems are fairly complex but, fortunately, fairly reliable. Beyond the simple power outage or clogged condensate drain line, more serious problems are best left to experienced, licensed technicians.

Signs that should lead you to call for service include:+ Unit running but no cool air coming out. If the appliance cools intermittently, it usually points to a problem with the refrigerant and may mean the system needs to be recharged.+ Odd sounds coming from the condenser/ compressor unit. Turn off the unit and call for service.+ The system doesn't come on at all. First check the obvious culprits--that the thermostat is set to cool and that the appliance's circuit breaker is in the "On" position.
best brand of ac unitsLikewise, check all other system switches or disconnects.
cheap central air conditioner unitsIf these aren't the problem, make sure the air-conditioner is off and call for help.+ Any significant leak or a dripping circuit breaker.
ac unit keeps starting and stopping

This should be dealt with immediately by a professional. Turn off the unit and make the call.The mercury is plummeting and you're trying to find all those extra sweaters because your oil furnace isn't coming on.Every oil-burner unit has a reset button that will trip from time to time. It's a red button on the box at the burner. Press it and the burner should fire right up, making your house a warm home again. However, do not try the reset button more than once.Some conditions are signs of bigger problems than most people can handle at home and require the help of a heating pro. According to John Levey, owner of Oilheat Associates in Long Island, New York, and the director of education for the Oil Heat Institute of Long Island, these include:+ Chimney smoke. Oil burners typically give off smoke from the chimney and/or soot in the boiler room when combustion problems arise. These early warning signs indicate the need for professional attention and are often caused by minor problems that can be repaired quickly and inexpensively.

If they are not promptly repaired they can lead to more serious trouble and more expensive repairs.+ Burner doesn't run. Oil burners require electricity to operate, so the first things to check are the large wall-mounted shutoff switch and the circuit breaker or fuse. If the switch and breaker are in the "On" position and the burner still doesn't fire, press the reset button on the primary control once. Never press the reset more than once because doing so can cause serious problems. If the burner starts and continues to run after the reset button is pushed it's important to understand that it went into reset for a reason. Chances are that there's a minor problem that requires professional attention.+ The system doesn't come on at all. If these aren't the problem, make sure the air-conditioner is off and call for help.+ Cycling too frequently. Burners normally cycle on and off numerous times during the day, but if the unit is continually cycling it may be a sign that the controls are not properly adjusted or, on warm-air systems, that the filters have become clogged.

Before calling a professional, check your air filters and, depending on the model, replace or clean them if they've become clogged.+ Odors. Oil heat systems should not emit odors. An odor can be a sign of an oil leak or of a combustion problem, both of which should be checked by a professional.+ Safety Reminder: Call in the spring or late winter to schedule an oil-heat tune-up in late summer or early fall. Also there should be working smoke and carbon-monoxide detectors located throughout the house. Using a portable air conditioner could soon be a little cooler on your wallet, thanks to new federal energy efficiency standards proposed this week by the Department of Energy. This is the first time that the standalone, moveable units that are not permanently installed in walls and windows will be required to operate with at least a minimum level of energy efficiency and savings. Until now, portable air conditioners have never been subject to an efficiency standard, and their performance has fallen behind other types of cooling equipment.

Consumer Reports considers this equipment to be the “cooling choice of last resort” because they’re most often used in situations where central air conditioners aren’t present and window units can’t be used and, in some cases, may even heat the room more. All of the mechanical portions of the equipment sit inside the room you’re trying to cool. Since conditioned air from the room is also used to cool the condenser and the hot air is then vented through an exhaust hose out a window, the machinery creates negative pressure in the room you’re cooling. This means that in some cases, warm air from the outside or other surrounding rooms is brought into the room with the portable air conditioner. Nearly a million portable air conditioners were purchased in 2012, and that number is expected to increase by almost 80 percent by 2018 so the action by the Department of Energy (DOE) is well-warranted. While the proposed standard released this week is a step forward for consumers, it unfortunately leaves a significant amount of potential savings on the table.

The standard level chosen by DOE was less stringent than some of the more aggressive (yet still cost-effective) options available. Nonetheless, the proposal will still benefit customers who replace their old portable air conditioners: residential customers can expect to save about $144 on their cooling bills over the lifetime of the product, and commercial customers will save almost $300. Over the next 30 years, DOE says, this standard will save 37.7 million metric tons of carbon pollution, which is equivalent to the annual emissions of nearly 8 million passenger vehicles, all while contributing to President Obama’s commitment to save 3 billion metric tons of carbon emissions from standards by 2030. Standards for other cooling equipment Fortunately, minimum energy-saving requirements are already in place for other products that keep our homes more comfortable in the warm months, such as central air conditioners & heat pumps, room air conditioners, ceiling fans, and dehumidifiers.

What’s more, all of these products are scheduled for improved standards because the available technology has advanced sufficiently to ensure they can waste even less energy. To be specific: updated standards for ceiling fans and dehumidifiers, last adopted in 2005 and 2007, are expected to be finalized by later this summer, and the energy-saving rule for room air conditioners is due to be updated next year. A “negotiated rulemaking” for central air conditioner (and heat pump) standards produced an agreement in January to recommend levels that are 7 percent to 8 percent more efficient than today’s least-efficient models. In any case, standards for all our cooling appliances ensure that all products meet certain performance criteria while saving money and energy when we purchase and install new models. With the weather getting warmer as we get closer to summer, it’s good to know that energy-saving standards for our cooling equipment will help ensure that our utility bills don’t burn our wallets as the temperature rises.